3 Common Sander Problems - DoItYourself. com If the belt has no give, it is too tight and may cause a loud squeaky noise and overload the motor You will need to adjust the belt tension by working the hex head set screw until you get the proper play in the belt
Parkside Belt Sander Problems: Troubleshooting Guide However, users may encounter various issues such as motor overheating, unusual noises, belt slippage, and failure to start This comprehensive guide addresses common Parkside belt sander problems , providing troubleshooting steps, maintenance tips, and solutions to keep your tool running smoothly
Engine Squealing Sounds Like a Belt, But It’s Not? If you notice the engine squealing like a belt, but it’s not, you could be looking at a broken alternator bearing, power steering pump, idler pulley, tensioner, or a stuck PCV Also, it could be a collapsed hydraulic valve lifter in the worst-case scenario
Troubleshooting Common Issues With Sanders First, check to make sure that the sander is plugged in and that the cord is not damaged Next, check the sandpaper to see if it is worn out or clogged with debris If so, replace it with new sandpaper Finally, check the sander’s belt to see if it is loose or broken
Motor problem on sander - Family Woodworking Check the centrifugal switch on the back end of the motor, it might just need to be blown out with your air hose, sometimes sawdust messes with the contacts in there A sander that size probably has a universal motor Depending on the machine, it may or may not allow access to the brushes