70 AMX parts to AMO - The AMC Forum I'll be bringing my 3D printed custom AMX grilles to AMO ($1499 painted) as well as shadow mask stripe kits ($40 at show) I'll have discount grilles also that have had shipping damage repaired (broken tabs glued back in place, for example) I'm also bringing other parts that were not used in the build of my car:
1970 AMX inside hood release replacement - The AMC Forum Yes, you are correct about the 1970 AMX without an inside hood release However, my AMX came with one, perhaps from 71 AMX installed by PO I am trying to get a few measurements from APD Anyway, I do have a latch above the the license plate also
68 AMX Front Suspension - The AMC Forum If it helps any, with my 68 Amx currently sitting on the hoist the upper arms are also resting on the 'frame' with the suspension dangling (no shocks currently installed, if it matters) 1968 Amx - Was 390 4spd, will have mild 360 5spd T5 (project)
69 AMX fuel tank sending unit - The AMC Forum Glynn, If it is any help i bought the APD unit for a AMX and it was correct out of the box Lee 1971 SC360 Hornet 4 speed 1967 Rambler 220 X code 343 4 speed
Speedometer Calibration - The AMC Forum - Page 1 I have a 1969 AMX with a 390 4V and the Borg-Warner M12 Automatic The rear ratio (I have been told by the seller) is a 2 87:1 My speedometer is showing close to 70mph at 60mph (according to GPS)
Courtesy light - The AMC Forum - Page 1 Hello everyone, just recently purchased a 68 AMX, and I'm struggling with the courtesy lights They will not go out, it seems the mounting bracket is grounding the light instead of the switch However when I let the lights hang, they do go out, but then they won't come back on when I ground the wire in the switch
New Posts - The AMC Forum Discussion forum for American Motors cars and products, restoration details and more