Instruction Manual - Hi-Lift Jack Co. Note: You can connect the top clamp-clevis anywhere along the steel standard bar to use the jack as a clamp Operate the jack as you would for raising a load (see Raising a Stationary Load)
Hi-Lift Spreading, Clamping Extrication - YouTube Describes how to use the Hi-Lift Jack for spreading, clamping, and extrication purposes Details how the Hi-Lift Jack can be used by fire, rescue and emerge
High Lift Jack Mount I-Sheet - Quadratec Make sure the mount is straight vertical as the nuts are tightened The curved edge at the bottom of the weldment should sit flush against the tire carrier tube (figs 6 and 7)
Summit Racing Equipment BL-250 Protects your Hi-Lift Jack from weather, mud, dirt and sand, Made of durable vinyl-coated nylon, the Jack Protector is waterproof, as well as mildew and decay resistant Drawstring closure
Hi Lift Jack Mount - Polaris RZR Forum - RZR Forums. net It will be easier to get the jack out of the seats are tilted forward but that’s easy I welded taps on a piece of pipe I cut lengthwise I added trim on the edges and it clamps really tight But just in case I added a tapped hole on the backside for a set screw I like it
DIY Hi-Lift Jack Mount with a Softopper - Tacoma World Slip about 3 8" of 3 8" ID fuel hose over the bolt to protect the threads and help reduce rattles The 3 8" fuel hose is a nice snug fit in the Hi-Lift's riser bar climbing pin holes The jack is held on the brackets with 3 8"-16 clamping knobs