Allison Transmission 1000, 2000 Service Manual Install the 5 required pump cover to oil pump bolts, size identified in Figure 95 and location is identified in Figure 93, and torque the bolts to 27 Nm (20 ft lb )
Microsoft Word - Allison 1000_2000_2400 Inst. doc Using a 6 MM hex bit and 3 8 drive torque wrench, torque the zinc plated allen cap screws to (12-16 ft lbs ) in a “cross tight” pattern Check the drain plug and 1 8 pipe plug for tightness If you are going to install a temperature sender, do so at this time
REMOVAL INSTALLATION INSTRUCTIONS FOR THE Using two of the 15mm “stud” bolts at opposite sides (180° apart) of the torque converter, gently pull the converter out of the transmission while holding the studs for control with a drain pan beneath to catch any fluid
BD Diesel 1061600 Transmission Pan Installation Instructions INSTALLATION: Park the vehicle on flat and level ground with the park brake applied and the transmission in park Drain the transmission pan of any existing fluid and remove the 12 existing bolts that secure the pan to the transmission case Remove the pan slowly
Allison 1000 - Mag Hytec You may drain your transmission oil without removing the Mag-Hytec pan However, we recommend you remove the pan and change the filter at every transmission oil change
ALLISON 1000 SIGNATURE SERIES - Revmax Converters Allow transmission to shift all the way up to the sixth gear AND back down to the first at least 25 times If full power is given, immediate transmission failure will occur and you will be responsible for repair charges