Shop labor hours for 392 engine remove and reinstall I have removed engines from quite a few vehicles over the years Though I have yet to remove any engine from a Challenger, I have a hard time believing that a competent shop needs 10 hours to remove and another 10 hours to re-install the same engine
Missing Under Engine Shield - Dodge Challenger Forum Just looked underneath my 2021 RT and the plastic shield that covers the underside of the engine is gone, along with all four bolts! I sure as hell would have heard the thing come off while driving, and all four bolts would not have backed out at the same time
6. 4L entire engine replace because of lifter cam failure? If you buy the car with the 6 4l engine do the servicing on schedule and using the factory oil filter, avoid the idling (if you can and you can't), do this and then buy a rabbit's foot for good luck That's all that is standing between you and the engine failure
How-To: Remove and Replace Radiator - Dodge SRT Forum There's a little white butterfly tab that unscrews on the passenger side of the vehicle just left of the inlet charge pipe, you do not have to unscrew it all the way because the coolant drains from below and unscrewing that tab open a valve on the bottom of the radiator
For those changing the Serpentine belt - Dodge Challenger Forum When I first installed the super charger, I had my buddy rev the throttle and the belt jumped off and shot out the driver's side of the engine bay (snout was too short and I did not notice the misalignment)
The REAL difference in the 6. 4L and 5. 7L - Dodge Challenger Forum Your best bet is to swap the cam, intake and exhaust from the 6 4 onto your 5 7 You will be down on displacement, compression and cylinder head airflow, but you should be reasonably close You could stroke it to make up for the lack of displacement, but I think the above would be more than enough