Air 3s Gimbal Overload warning and now Gimbal Stuck Tried a gimbal calibration and it would not complete past 60% I left it over night and this morning I have appeared to only make it work as now it says gimbal stuck and gimbal reset only makes it to 40% On start up the gimbal does not appear to go through it system check Here is what I have done
Gimbal calibration after repair, I am stuck, Mavic Mini but may apply . . . I rebuilt a gimbal from a crashed mini, I put the camera in a 'new' gimbal frame and motors The camera works and the gimbal does the boot dance, moving about all three axis (which is a plus) seemingly perfectly to my eyes but comes up with gimbal stuck message etc etc as was more or less
Looking for software for gimbal calibration | DJI Mavic, Air Mini . . . As some of you are aware, when you switch the gimbal in a mavic air and other models you need software to calibrate the new part, you have to be a certified DJI engineer to get a copy, does anybody have a copy? Or can point me in the right direction to get this software?Thanks
Gimbal Overload Error? | DJI Mavic, Air Mini Drone Community Sometimes the gimbal would power up normally, and other times it wouldn't - sometimes it even tilted during flight, and the last flight it "jittered" Today I powered it up and did a gimbal calibration, downloaded the DJI Assistant 2 software and updated the firmware (even though it said I had the current version), calibrated the sensors and
DIY replacement of gimbal. All was good but suddenly video is gone . . . Thank, the gimbal works perfect and very smooth I have triple checked all connections It's just video that is complete dead, mind that it did work perfect after replacement of the gimbal I re-used the original camera I will now try to replace the new camera ptz-cable I have installed along with the new gimbal Maybe I got a bad one that's already broken
HOW TO: Replace Mavic Pro gimbal ribbon cable (detailed instructions) Here's a detailed video from iRepairMD that shows how to replace the Mavic Pro gimbal ribbon cable (from start to finish): Note: The DJI warranty states the Mavic warranty could be voided if any work is done by a non-authorized service provider (which includes yourself) If that's not a
Gimbal Error 40002 - but Movement during startup is normal Hi, the Gimbal moves normally during Startup-Sequence However, in the app the Gimbal-Stuck message pops up Also, when flying, the Video is shaky When moving the Mini on ground, the gimbal does not seem to stabilze It remains fixed relative to the drone Up to now, I: - refreshed the