How to make lanolin case lube - Brian Enoss Forums I have a bunch of lanolin on hand from non reloading use I've seen posts mention mixing it with isopropyl alcohol to make case lube,but I tried it last week and only got a gooey mess How do you mix it up?
What Case Lube Recipe Are YOU Making Using for YOUR cases On 3 21 2020 at 3:04 AM, cool said: I use lanolin at 3 or 6% for 9mm 38 357 40 45 223 with isopropyl alcohol Seems like alot of lanolin to me Are you using carbide sizing dies? How are you removing the lube before reloading
Post your case lube recipes - Brian Enoss Forums Title says it all If you use a commercial case lube (or other store bought lubricant), please post that as well I use a mix of Lanolin and alcohol in a quart sized spray bottle (I forget the exact mix ratio) Never had any issues with dead primers or squibs Spray a couple spritzes in gallon si
Removing lanolin case lube - Brian Enoss Forums I've been experimenting with a light lanolin and alcohol mix on my 9mm cases to see if it makes resizing smoother on my 550 Not quite sold on it yet, but problem is removing this stuff from completed rounds I have corn cobb in a Dillon tumbler and added some mineral spirits No bueno Any ideas
Tumble completed rounds (coated bullets) to remove case lube? If I sprayed my cases with a bit of lube (lanolin + isopropyl alcohol) to make sizing easier, can I dry tumble them after to remove the lube, or will that adversely affect the coating thickness on the bullets? I'm using Blue Bullets, in 9mm I tumbled a test batch (vibratory tumbler, using Lizard
Removing lanolin case lube - Page 2 - Brian Enoss Forums I started using the infamous bootleg case lube, one 12oz bottle of Heet (red bottle is 99% isopropol alcohol) and one oz of liquid lanolin in a spray bottle Spray 2-3 shots into a large bag, dump a lot of brass in, roll brass around in bag, dump out into cardboard box lid to dry a few min, dump into case feeder, load and shoot
Lubing pistol brass - 9mm 38 Caliber - Brian Enoss Forums For those that lube their brass with peg 75 lanolin mixed with iso alcohol, do you make sure every piece is laying side ways? I usually tumble rifle brass after lining and sizing, but with pistol, I plan on just sizing and loading in 1 step How critical is it to keep it out of the case mouth? Wi
Case lube options - General Reloading - Brian Enoss Forums Also Lanolin 99% for lube This time after wash and wax I drained water, refilled and added about 1 5oz of Lanolin and ran for 10 minutes then didn’t rinse off Have been loading with no additional lube and this has worked pretty well I still after loading 3-4 hundred spread them out on a towel and wipe off with alcohol to remove any excess
Shooting without removing case lube? - Brian Enoss Forums Hahaha I seriously have never even considered re-tumbling rounds after loading them IDK, but IMHO if one has to re-tumble to remove case lube, then they're using way too much in the first place I use the Frankford Armory case lube lanolin+alcohol stuff (basically same as the Dillon stuff) and a few squirts goes a long way