How to connect Raspberry to two Wi-Fi different networks simultaneously The answer is yes to both questions -- or at least, you can add one usb wifi and use that and the onboard one simultaneously You may notice that one or both connections slow somewhat (I have a Pi that does this regularly for a few hours, but the slow down is just a suspicion I have not investigated to confirm)
How to drive two stepper motors simultaneously I encountered issues when adding a second motor The GIL does not allow for both threads to run simultaneously Mi solution was to add a centralized stepping class (Navigation) and have it ran by a dedicated python process (so your app does not compete) The readme shows how to initiate the motors I ise a motor Hat with two DRV8825 onboard
Unable to Use Arducam IMX708 and Arducam ToF Camera Simultaneously on . . . I followed all instructions from the Arducam documentation to set up and run the ToF camera I used Picamera2 to configure the IMX708, and it works fine independently However, running both cameras simultaneously does not work, and I have to modify config txt each time to switch between them
raspbian - Is it possible to simultaneously use the dual band(2. 4 Ghz . . . Is it possible to simultaneously create a single AP on raspberry pi 3 b+ which uses both 2 4 Ghz and 5 Ghz bands so that users with low end devices can connect to the 2 4 Ghz band and users with latest or high end devices can connect to the 5 Ghz band? If so, what is the hostapd for that configuration?
Can RPi4 run simultaneously on dual band (WiFi 2. 4GHz 5GHz)? Yes, it is possible to run a RPi 4B simultaneously on dual band (WiFi 2 4GHz 5GHz), but only with predefined interface combinations given by the hardware If one interface is used as access point (AP) you can only use one band First to clarify: you are talking about RPi 3B, the link you have given is talking about a RPi 3B+ This is an
rpi. gpio - Control motors and servos simultaneously (Python . . . I have a Raspberry Pi 2B+ and some knowledge of Python I need to control a DC motor, two servos and a LED simultaneously The requirements are: Must control two servos, a LED and at least 1 DC motor (obviously) Must be compatible with the Raspberry Pi 2B+ (obviously) Must be controllable through Python and GPIO
Raspberry Pi Zero 2 W simultaneous AP and client I want to find a method to use the Raspberry Pi Zero 2 W's inbuilt WiFi chip as both a WiFi AP and client simultaneously – Ash Skabo Commented May 11, 2023 at 19:11