Saitek Pro Flight Rudder Pedals not recognized anymore After update to Windows 11 24H2 my pedals are not recognized anymore! The device manager is showing and reporting them as USB device, but there is a remark that they have not been ported correctly by the update Change USB ports, restarted, searched for updated drivers also with Logitec, nothing
MSFS 2024 rudder left and right axis - AxisAndOhs Support - AVSIM Try just assigning the rudder axis event to your two axis in parallel, without changing min and max In general, you can always assign the same axis variable or event to multiple levers and change Axis Min and Axis Max values to each cover only a portion of the resulting value
Honeycomb Charlie rudder pedals not working correctly It will also depend on the way the specific aircraft he is using models its steering - for example, a Cessna 172 is only steerable to about 10 degrees right or left with the rudder pedals, so sharper turns would need to use the brakes I would think the first task is to establish a full range of rudder control, then investigate further from there
Thrustmaster Rudder TPR does not act as it should: solution! - AVSIM MSFS and or AOO sees the Rudder not as slider, but as axis with a center position in the middle Therefore it is not possible to brake as brakes center at 50% if you step off the brakes or they do act otherwise strangely Solution: DO NOT use windows joystick calibration! If you have the problem, follow these steps prvided by Thrustmaster itself:
Unable to set rudder axis - Microsoft Flight Simulator (2020 2024 . . . Good morning I have not been successful in setting the rudder axis in my C208, Fs 2020, in Controls, Axis and Ohs and even Spad next It will however set in FSUIPC I do not have anything else assigned in FSUIPC and would prefer system Controls or AAO This was not a problem until recently and rudder axis assignment was ok before
Control Settings - MSFS2024 - Microsoft Flight Simulator (2020 2024 . . . I am playing around with the Control settings "Device Lists" for my Mouse, Keyboard, Tobii, Alpha, Bravo and Saitek Rudder Pedals Just trying to feel my way around the setup menus It appeared very complicated and daunting at first and still is to a degree But I think after navigating through t
iFly 737 Max8 comments and questions - AVSIM PMDG isn't modeling nose wheel steering with rudder pedals correctly This is true for the 737 and 777 (I have both) After a very tiny amount of rudder input you already get the full 7 degrees of nose wheel deflection The 7 degrees should be spread across the whole rudder deflection
Fenix A321 Stability During Takeoff Roll - AVSIM The rudder on the A320 is REALLY powerful so you still have effectiveness at VMCG (minimum ground effectiveness) - the purpose of this is to be able to counteract the asymetric thrust if an engine were to fail at lower speeds but high thrust output (i e before V1, at TOGA) - the rudder is so powerful that the aircraft itself will limit
Fenix: Tiller logic wrong? - AVSIM On the real aircraft, "PEDAL DISC" is a momentary button (meaning that it reverts back to the "up" position once you release pressure on it) Its purpose is to disconnect the rudder pedals from the nosewheel steering so that you can do a rudder control check during taxi without causing the aircraft to change direction
iFly 737 Max8 comments and questions - Page 2 - AVSIM PMDG isn't modeling nose wheel steering with rudder pedals correctly This is true for the 737 and 777 (I have both) After a very tiny amount of rudder input you already get the full 7 degrees of nose wheel deflection The 7 degrees should be spread across the whole rudder deflection