Sidewinder Problems and Warranty Items. | Page 7 | TY4stroke . . . 02 19 2018 - 2018 Sidewinder LTX LE - 1865 miles - lost the sight glass, fell inside the chain case Did a trail side fix and limped back 25 miles, painful Took it to the dealer, no explanation as to why The sight glass was sitting in the bottom of the chain case unharmed My feeling, nothing holding it in Whatever they used (bead of something) didn't hold The reason I say this is I
Sidewinder helix options, product update - ty4stroke. com Hi Guys Thought I'd post a bit of info here since the sidewinder and the way it gets set up is relatively new and a lot of new testing ongoing We get a lot of questions about helixes Sometimes we are mistaken for a clutch kit company, and some are not as familiar with what we do here, so we
Sidewinder not starting | TY4stroke: Snowmobile Forum | Yamaha - 4 Stroke We were at a gas station yesterday and I noticed a guy’s Sidewinder not starting The cluster would not turn on and the fuel pump would not cycle The guys played with his kill switch and they were finally able to fire it up Then his buddy’s Thundercat did the exact same thing The outside
Sidewinder Problems and Warranty Items. | Page 5 | TY4stroke . . . I don't know It just started smoking I think its an oil line that blew near the muffler I spoke to the tech at the Yamaha dealer in Sault Ste Marie and that's his thought I will know for sure tomorrow morning I'm hearin g some Sidewinders are blowing the chaincases up north here It couldn't have been that- I drove it 5 kms after it started smoking, shut it off Then drove it into the
TY4stroke: Snowmobile Forum | Yamaha - 4 Stroke A forum community built to help fellow 4 stroke Yamaha Snowmobile owners with Technical issues, Tuning and Maintenance We take pride in our product and want all owners to have a wonderful experience with theirs Also watch for our scheduled TY Rides and Events
linQ saddle bags. . . Anyone setup on a SW? I want more storage for those 3+ day tours Currently running 2 X 21L linQ bags on a UNP dual rack setup but was looking at the linQ saddle bags as added storage I see how they integrate into the existing clamp system and they hang down on the sides I am just concerned about clearance on
Getting rid of the roll over valve - ty4stroke. com This is what I’ve done to get rid of the problematic valve Just a hardware store 5 8" ID hose wrapped with foil heat tape, looped it up and over down to under the running board Let bottom hang and inch or two below the board You can see how much blowby you have also I plugged the line where