Mega timers - Programming - Arduino Forum The PWM pins are shown but I can't find which timer controls which PWM output I need to change the PWM frequency of the PWMs I use if needed I need a PWM frequency of about 31kHz and need to setup the appropriate timer control register for that (I use 10 PWMs of the Mega and need to make sure the correct frequency gets to the correct PWM)
Use of Timer 2 in Arduino UNO Iam beginner with arduino and learning Interrupts , Stuck at a point while doing my project , I want to know how to use timer 2 for interrupt , i wrote a small peace of code , after every 10ms i want to monitor a sensor input
Watchdog timer WDT - prevent esp32 from stucking i have esp32 and using arduino ide (2 0 18 board version) im trying to add a code that prevent esp from blocking so if it stuck for some reasons to restart it i found following code but is not working #include "esp_task_wdt h" #include <WiFi h> #include <HTTPClient h> Define timeout in seconds (3minutes = 180seconds) #define WDT_TIMEOUT 180 void setup() { esp_task_wdt_init(WDT_TIMEOUT
FspTimer: using AGT timer issues - UNO R4 Minima - Arduino Forum Servo test program servo_timer_config: type:1 Channel: 1 Raw Period: 960000 Note: servo_timer get_period_raw() returned a period of 960000 Which does not make sense, as I am pretty sure this is a 16 bit counter Wonder maybe it did not like to do a period that long So tried changing to 1500 Raw Period: 71999 Tried 750 -> 35999 Thoughts?
Timer ISR - Programming - Arduino Forum Arduino Timer Interrupts: Timer interrupts allow you to perform a task at very specifically timed intervals regardless of what else is going on in your code In this instructable I'll explain how to setup and execute an interrupt in Clear Timer on
Timer Interrupts and PWM Pins - Programming - Arduino Forum Those pins are normal digital pins The timer input and outputs connected to those pins are something extra The Timers will only use the pins if that is programmed in the registers Even the A0 A5 are normal digital pins, The analog section is an extra The interrupt pins, the I2C bus, the SPI bus are all something extra for normal digital