Honda Accord Forums - Drive Accord Honda Forums On my 04 had valves adjusted @ 250K, 350K 450K Mechanic said adjustment not necessary unless they are making noise even though the Honda recommendation was to check them @ 120K Call some indy shops for prices, quality of job will depend on time spent doing the adjustment That dealer quote would be $200 hr 2 hrs
Why breaking in a barrel is NOT necessary - Snipers Hide Re: Why "breaking in" a barrel is NOT necessary The reason that the barrels change velocit is the bore actualy work hardens and if you fire yout rifles at say 500 yards you can see an elevation shift somewhere around 50 to 80 rounds then they usualy settle down the reason to break in barrels is to smoth out the burs in the throat
will honda dealer replace all necessary parts for timing. . . The price I got was $1,500, which seems to be the average in the NY area I used a 10% service coupon, so the final cost was around $1,300 When I dropped off the car, I confirmed again that everything was being replaced, and they assured me it was a full kit with all necessary parts Today, when I picked up the vehicle, the invoice only listed:
Is it really necessary to change the drain plug washer. . . Some may say it's ok to do that, but I say it is foolish for the sake of a $ 35 washer to take any chances When the washer "crushes" at 30 lb-ft of torque it forms a leak-free seal and the drain bolt will not loo
Is flushing the coolant system necessary? - Drive Accord Honda Forums I would not do a chemical flush but just a flush with a hose, while the water pump is off In my opinion using distilled water to flush is a bit overkill Also, insisting on Honda coolant is a fine but not necessary if you are flushing the whole system (be sure to get the heater core)
Is a S-VCM absolutely necessary for 9th gen V6? I've been told I need to get an S-VCM module as soon as possible to disable vcm on my 9th gen due to uneven piston wear and generally extra wear being caused by the VCM However I've also read that those issues only pertain to the 8th gen and they were all resolved with the 9th gen Any
Cantilevered mount necessary on Ar10? | Snipers Hide Forum If you don't have a full length rail and are using a long scope like a NF NXS 5 5-22X50 or a Burris XTR II 5-25X50 or some thing similar you would need a cantilever mount to get the scope mounted with the proper eye relief Or you might be able to use a LaRue like the SPR If you have a full length rail the a cantilever mount is not necessary
Is brake fluid change really necessary? - Drive Accord Honda Forums I was reading through the manual for our 2014 Honda Accord and noticed it recommended replacing the brake fluid every 3 years I have owned three Hondas (1990, 1995, and currently a 2004) that all had have over 250,000 miles I have never done anything with the brake fluid with those three cars
Suppressors DIY Suppressor alignment gauges - Snipers Hide I'd found a thread on Reddit about using O-1 tool steel rods to make your own suppressor alignment gauges I have the Geissele 22 and 308 rods, but needed one for 6 5 barrels I'd been making do with using my 22 rod and rotating the rifle 90 degrees four times to check alignment The rods